200 SERIES 300 & 400 SERIES 500 SERIES 600 SERIES 700 SERIES 800 SERIES 900 SERIES 1000 SERIES 1100 SERIES 1200 SERIES CUSTOM MODELS OVERVIEW TABLE

XD747DB Data Sheet The Model XD747DB-J2-IND15-A30-B060 shown below is typical and representative of the XD747DB Models. For more information on specifying a holding fixture, see the 700 SERIES OPTIONS page and 700 SERIES CREATING A MODEL NUMBER pdf. Click for larger image  The maximum distance between mounting interfaces is directly related to the main beam length. Specify the distance between mounting interfaces to be at or slightly larger than the length of the part-to-be-handled. The fixture can be adjusted to accommodate smaller length parts, however, the main beam(s) extending from each end frame may be inconvenient. For more information see the 700 SERIES OPTIONS page and 700 SERIES CREATING A MODEL NUMBER pdf.  Addition of the optional SR or DR gearbox decreases the vertical riser adjustment from 10" to 8" and increases the minimum trunnion height from 36.7" to 38.7". * Note: Adjusting unit to dimensions smaller than 37" can cause tip over due to small footprint. Product Features: Safety Factor: 3 Rated Load Capacity:   Dynamic, 0" eccentricity: 1,300 lbs. (590 kg.)   Dynamic, 5" eccentricity: 1,080 lbs. (490 kg.) Operating Temperature: +32 to +104 °F (0 to +40 °C) Contact factory for special applications with extended operating temperatures. Choice of Trunnion Interface/Mount/Clamp Options: Angle Interface Mounting Plate Interface Choice of Main Beam Length Main Beam Ball Lock Pins: Reliably prevents End Frames from slipping on Main Beams Gearbox: 60:1 ratio with 12" diameter crank Casters: 5" diameter x 2" wide wheel with polyurethane tread, sealed swivel bearing and Tech-lock brake Materials: Steel construction Finish: Blue Paint or Powder Coat (at manufacturer's discretion), with selected parts zinc plated. Other finishes available upon request Price Range: $7K - $26K Click for larger image Optional Main Beam Lengths Optional Trunnion Interface/Mount/Clamp Optional Index Plate Optional Index Stops Optional Casters Optional Leveling Jacks Optional Gearboxes incorporating heavy duty, low backlash and stairstep resistant features Optional finishes for clean room compatibility Optional Ground Lug and Drag Chain for use in electrostatically protected areas (EPA's) For more about 700 Series Options click here All data presented is based on no modifications to the product. As Flotron is constantly improving products and methods of manufacturing, we reserve the right to modify and/or change design or specifications without notice. Please contact Flotron for verification of critical dimensions and specifications. For 700 Series - Creating a Model Number pdf click here. - Note: viewing this document requires Adobe's Acrobat Reader. For clarification of terms or phrases, please see the Holding Fixtures Definitions page.

Product Features 700 Series Options Holding Fixture Definitions Model XD747db Dynamic Loading Chart 700 SERIES Creating A Model Number ( 13.9KB )

About Flotron | Holding Fixtures | Extractors | Product FAQs Tech Section | Contact Flotron Site Map | Help Flotron, Inc. 2485 Coral Street Vista, CA 92081 (ph.) 760.727.2700  (fax) 760.727.3957