2485 Coral Street Vista, CA 92081 USA (ph.) 760.727.2700 (fax) 760.727.3957

The Model HD664-SR-IND15-B063-C1 shown below is typical and representative of the HD664 Models. For more information on specifying a holding fixture, see the 600 SERIES OPTIONS page and the 600 SERIES CREATING A MODEL NUMBER pdf.  The maximum distance between mounting interfaces is directly related to the main beam length. Specify the distance between mounting interfaces to be at or slightly larger than the length of the part-to-be-handled. The fixture can be adjusted to accommodate smaller length parts, however, the main beam(s) extending from each end frame may be inconvenient. For more information see the 600 SERIES OPTIONS page and 600 SERIES CREATING A MODEL NUMBER pdf.  A smaller than standard swing radius may be recommended for some applications. See the "Technical Section" under "Holding Fixture Safety" on page 3 of 7 concerning "Unexpected Accident Loads" and the chart on page 4 of 7 referring to "Maximum Recommended Swing Radius" * Note: Adjusting unit to dimensions smaller than 52" can cause tip over due to small footprint. Back to HD664