Flotron: Holding Fixtures




	200 SERIES

	300 & 400 SERIES

	500 SERIES

	600 SERIES

	700 SERIES

	800 SERIES

	900 SERIES

	1000 SERIES

	1100 SERIES

	1200 SERIES

	CUSTOM MODELS

	OVERVIEW TABLE

HD510 Data Sheet

The Model HD510-1023-IND15-B048 shown below is typical and representative of the HD510 Models. For more information on specifying a holding fixture, see the 500 SERIES OPTIONS page and 500 SERIES CREATING A MODEL NUMBER pdf.

Click for larger image

The maximum distance between mounting interfaces is directly related to the main beam length. Specify the distance between mounting interfaces to be at or slightly larger than the length of the part-to-be-handled. The fixture can be adjusted to accommodate smaller length parts, however, the main beam(s) extending from each end frame may be inconvenient. For more information see the 500 SERIES OPTIONS page and 500 SERIES CREATING A MODEL NUMBER pdf.

A smaller than standard swing radius may be recommended for some applications. See the "Technical Section" under "Holding Fixture Safety" on page 3 of 7 concerning "Unexpected Accident Loads" and the chart on page 4 of 7 referring to "Maximum Recommended Swing Radius"

Product Features:

Safety Factor: 2
Rated Load Capacity:
Dynamic, 0" eccentricity: 175 lbs. (79 Kg.)
Dynamic, 5" eccentricity: 175 lbs. (79 Kg.)
Operating Temperature: +32 to +104 °F (0 to +40 °C)
Contact factory for special applications with extended operating temperatures.
Choice of Trunnion Interface/Mount/Clamp Options:
Angle Interface
Mounting Plate Interface
Board Clamp
Choice of Main Beam Length
Main Beam Ball Lock Pins: Reliably prevents End Frames from slipping on Main Beams
Casters: 5" diameter x 2" wide wheel with polyurethane tread sealed swivel bearing and Tech-lock brake
Gearbox 50:1 ratio with 6" diameter crank
Materials: Steel construction
Finish: Blue Paint or Powder Coat (at manufacturer's discretion), with selected parts zinc plated. Other finishes available upon request
Trunnion Brake Knob
Price Range: $3,200 - $7,700

Click for larger image

Optional Main Beam Lengths
Optional Trunnion Interface/Mount/Clamp
Optional Index Plate
Optional Casters
Optional finishes for clean room compatibility
Optional Ground Lug and Drag Chain for use in electrostatically protected area (EPA's)
For more about 500 Series Options click here

All data presented is based on no modifications to the product.

As Flotron is constantly improving products and methods of manufacturing, we reserve the right to modify and/or change design or specifications without notice. Please contact Flotron for verification of critical dimensions and specifications.

For 500 Series - Creating a Model Number pdf click here. - Note: viewing this document requires Adobe's Acrobat Reader.

For clarification of terms or phrases, please see the Holding Fixtures Definitions page.




			Product Features

			500 Series Options

			Holding Fixture Definitions


			Model HD510


			500 SERIES Creating A Model Number ( 13.2KB )