2630 Progress Street Vista, CA 92081 USA (ph.) 760.727.2700 (fax) 760.727.3957 The Model HD410-SA10-B048-5 shown below is typical and representative of the HD410 Models. For more information on specifying a holding fixture, see the 400 SERIES OPTIONS page and the 400 SERIES CREATING A MODEL NUMBER pdf.  The maximum distance between mounting interfaces is directly related to the main beam length. Specify the distance between mounting interfaces to be at or slightly larger than the length of the part-to-be-handled. The fixture can be adjusted to accommodate smaller length parts, however, the main beam(s) extending from each end frame may be inconvenient. For more information see the 400 SERIES OPTIONS page and 400 SERIES CREATING A MODEL NUMBER pdf.  Addition of an optional index plate decreases the vertical adjustment from 10" to 8" and increases the minimum trunnion height from 35.1" to 37.1".  A smaller than standard swing radius may be recommended for some applications. See the "Technical Section" under "Holding Fixture Safety" on page 3 of 7 concerning "Unexpected Accident Loads" and the chart on page 4 of 7 referring to "Maximum Recommended Swing Radius" Back to HD410