Flotron: Holding Fixtures




	200 SERIES

	300 & 400 SERIES

	500 SERIES

	600 SERIES

	700 SERIES

	800 SERIES

	900 SERIES

	1000 SERIES

	1100 SERIES

	1200 SERIES

	CUSTOM MODELS

	OVERVIEW TABLE

848 Data Sheet

The Model 848-J5-IND15-P12/A30-B074 shown below is typical and representative of the 848 Models. For more information on specifying a holding fixture, see the 800 SERIES OPTIONS page and 800 SERIES CREATING A MODEL NUMBER pdf.

Click for larger image

The maximum distance between mounting interfaces is directly related to the main beam length. Specify the distance between mounting interfaces to be at or slightly larger than the length of the part-to-be-handled. The fixture can be adjusted to accommodate smaller length parts, however, the main beam(s) extending from each end frame may be inconvenient. For more information see the 800 SERIES OPTIONS page and 800 SERIES CREATING A MODEL NUMBER pdf.

A smaller than standard swing radius may be recommended for some applications. See the "Technical Section" under "Holding Fixture Safety" on page 3 of 7 concerning "Unexpected Accident Loads" and the chart on page 4 of 7 referring to "Maximum Recommended Swing Radius"

Product Features:

Safety Factor: 3
Rated Load Capacity:
Dynamic, 0" to 3.5" eccentricity: 2,600 lbs. (1,179 kg.)
Dynamic, 10" eccentricity: 940 lbs. (426 kg.)
Operating Temperature: +32 to +104 °F (0 to +40 °C)
Contact factory for special applications with extended operating temperatures.
Combination Mounting Plate / Angle Interface
Choice of Main Beam Length
Main Beam Ball Lock Pins: Reliably prevents End Frames from slipping on Main Beam
Gearbox: Low backlash, non-backdriving stairstep resistant design with 250:1 ratio and 8" diameter crank
Self Aligning Couplings: These zero backlash couplings allow about ½ degree misalignment between load and fixure.
Gearbox Hub: The zero backlash gearbox hub attaches the gearbox shaft to the index plate and mounting interface. The hub is designed to withstand both torque and overhung loads.
Casters: 8" diameter x 3" wide wheel with polyurethane tread, kingpinless swivel bearing, Tread Lock brake and swivel lock
Index Plate: Standard with 15° index plate and index stops
Materials: Steel construction
Finish: Blue Paint or Powder Coat (at manufacturer's discretion), with selected parts zinc plated. Other finishes available upon request
Price Range: $38K - $64K

Click for larger image

Optional Ground Lug and Drag Chain for use in electrostatically protected areas (EPA's)
Optional Main Beam lengths
Optional Leveling Jacks
Optional finishes for clean room compatibility
For more about 800 Series Options click here

All data presented is based on no modifications to the product.

As Flotron is constantly improving products and methods of manufacturing, we reserve the right to modify and/or change design or specifications without notice. Please contact Flotron for verification of critical dimensions and specifications.

For 800 Series - Creating a Model Number pdf click here. - Note: viewing this document requires Adobe's Acrobat Reader.

For clarification of terms or phrases, please see the Holding Fixtures Definitions page.




			Product Features

			800 Series Options

			Holding Fixture Definitions


			Model 848
			Dynamic Loading Chart


			800 SERIES Creating A Model Number ( 70KB )