|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|
600 Series Standard Options: Optional Main Beam Lengths (BXXX): Main Beams may be ordered in any length between Trunnion Interface Mounts within the limits shown below. "XXX" = length in inches between trunnion interface mounts (1" increments).
Lengths shorter than the MIN shown above can be dangerous due to tip over. Lengths longer than MAX shown above require a special beam. While the two End Frames can be adjusted toward each other to accommodate smaller length parts, excessively long beams with a small part will leave the Main Beams extending from each End Frame enough to be inconvenient. It therefore is desirable to order the Main Beam close to the size of the actual part-to-be-handled. Optional Trunnion Interface/Mount/Clamps:
(Available only with SR or DR option)
 
Indexed @ 15° increments to prevent trunnion rotation with a lock pin. The Index Plate can be supplied with the P8 Mounting Plate Interface (not on SR or DR) (shown below), the A30 Angle Interface, or the P12 / A30 Combination Mounting Plate / Angle Clamp (for SR or DR only). 
Optional Index Plate with Index Stops (INDS15): Identical to the IND15 option shown above but with the addition of two Index Stops. The Stops can be bolted into any of the Index holes in the Index Plate to prevent rotation beyond a desired point. This can be a desirable option if your part-to-be-handled has a protrudance that could hit the main beam or floor or other obstacle when rotated beyond a certain orientation. 
Optional Split Pillow Block Trunnion Bearings (SPB): For use with lightweight balanced loads such as solar panels or wire harness boards. The Split Bearings are supplied less Gearbox and are mounted on both Risers. With each Split Bearing is a Stub Shaft that includes an IND15 Index Plate and your choice of either the P8 or A30 Interface/Mount/Clamp. Usually, the Interfaces are attached to a "customer supplied" handling frame. By removing the top half of the Split Bearings, the entire "customer supplied" handling frame and part can be removed from the fixture using an overhead lifting device. An additional feature is the Brake Handle that when tightened can clamp the Split Bearing against the Stub Shaft to create a braking resistance to rotation. Of course, to prevent rotation, the Index Pins must be inserted into the two Index Plates. 
Optional Heavy Duty Gearbox:
For use in electrostatically protected areas (EPA's). Proper electrostatic discharge (ESD) grounding of the fixture must be part of the overall EPA design. (See Technical section descussion on ESD. Special Options: If a standard Holding Fixture does not meet your requirements, contact FLOTRON about custom modifications. Often minor modifications to a standard unit are all you will need and can be done cost efficiently. For Specifications Sheet which will aid you in determining special options, click here. For 600 Series - Creating a Model Number, click here.* *Note: viewing these documents require Adobe's Acrobat Reader. For clarification of terms or phrases, please see the Holding Fixtures Definitions page. All data presented is based on no modifications to the product. As Flotron is constantly improving products and methods of manufacturing, we reserve the right to modify and/or change design or specifications without notice. Please contact Flotron for verification of critical dimensions and specifications. |
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
 About Flotron | Holding Fixtures | Extractors | Product FAQs Tech Section | Contact Flotron Site Map | Help Flotron, Inc. 2630 Progress Street Vista, CA 92081 USA (ph.) 760.727.2700 (fax) 760.727.3957 |
