Flotron: Holding Fixtures




	200 SERIES

	300 & 400 SERIES

	500 SERIES

	600 SERIES

	700 SERIES

	800 SERIES

	900 SERIES

	1000 SERIES

	1100 SERIES

	1200 SERIES

	CUSTOM MODELS

	OVERVIEW TABLE

200 Series Standard Options:

Optional Cross Beam Lengths (B XXX):
The Cross Beam may be ordered in either of 2 standard lengths. For the style 202 & 212 fixtures, the beam may be ordered as either a B-028 or B-022 (maximum distance between Trunnion Interface Mounts is either 28" or 22".) As an option, the beam may be special ordered in lengths from 18" to 120" (distance between interface mounts from 10" to 112"). For the style 208 & 218 fixtures, the beam may be ordered as either a B-027 or B-015 (maximum distance between Trunnion Interface Mounts is either 27" or 15".)

Optional Trunnion Interface/Mount/Clamp:

Angle Interface (SA10) - The Angle Interface offers the most adaptability for customers. Either of the 2" perpendicular surfaces of the angle may be bolted or clamped to. The standard length is 10 inches with no bolt holes. The standard finish is clear zinc plate.
Mounting Plate Interface (1018) - The part-to-be-handled can be easily bolted to this flange type interface. The standard size is 2" by 12.5" with a slotted-hole bolt pattern centered on the plate. The four holes will accept up to ¼" diameter bolts. The standard finish is clear zinc plate.
Board Clamp Interface (1023) - The Board Clamp Interface is a 10" long 2" x 2" angle with two screw clamps. It is very convenient for harness boards and similar shaped loads.

Optional Index Plate (IND15):
Indexed @ 15° increments to prevent trunnion rotation with a lock pin. An Index plate can be supplied with either of the mounting interfaces, shown below or the SA10 angle interface.

Optional Fixture Finishes for use in Clean Room (C):
The fixture is supplied with most surfaces electroless nickel plated, the gearbox case (when ordered) is painted with white epoxy and miscellaneous hardware is made of stainless steel.

Optional Ground Lug (E):
For use in electrostatically protected areas (EPA's). Proper electrostatic discharge (ESD) grounding of the fixture must be part of the overall EPA design. (See Technical section discussion on ESD.

Special Options:
If a standard holding fixture does not meet your requirements, contact FLOTRON about custom modifications. Often, minor modifications to a standard unit are all you will need and can be done cost effectively. For 200 Series - Creating a Model Number, click here.*

*Note: viewing this document requires Adobe's Acrobat Reader.

For clarification of terms or phrases, please see the Holding Fixtures Definitions page.

All data presented is based on no modifications to the product.

As Flotron is constantly improving products and methods of manufacturing, we reserve the right to modify and/or change design or specifications without notice. Please contact Flotron for verification of critical dimensions and specifications.

Back to 200 Series Product Line




			Angle Interface

			Mounting Plate Interface

			Board Clamp Interface

			Scissors Clamp Interface


			Holding Fixture Definitions


			SA10 Angle Interface
			1018 Mounting Plate Interface
			1023 Board Clamp Interface


			200 SERIES Creating A Model Number ( 9.8KB )